9053 helicopter help

[cdog0809]

i bought the 9053 volition helicopter it worked gr8 when i first flew it but i crashed it more than once i broke a few things i replaced the main blades,the balance bar,but now i go to fly it it goes every where wont hover in 1 place and also the screws that holds the main bottom blades to the outer shaft comes loose all the time and they are the same screws that came out of it when i replaced the ones i broke


q #1 what would make it not hover in 1 place
q#2 why would my main blade screws come loose it's just the bottom blade thanx for helping

[TracaR]

there are many things that can make your bird fail in a hover.
check that everything moves freely. check all you 2 linkages and such, make sure nothing is binding. !!

since it is a coaxial heli. (upper and lower ) blades there will be 2 motors to run and control the main blades. check that both the motors spin freely
also check that your main shaft isnt bent.

and last .. check your controller board. this can burn out if the heli was given full power and the blades could not spin.

let me know how this turns out.

[cdog0809]

i did what u said to check i took inner shaft out and looked at it it was fine didn't look bent
also check to see if everything was moving freely and it was fine and as for the controller board not sure how to check that

[TracaR]

there are a few things left to check...
make sure all the trims on the radio are set to zero. and rebind !!

there is only one way to test a board and thats to replace it


could you go into detail as to how the heli flys.

[cdog0809]

well when it lifts off the ground and i try to keep it hovering it goes everywhere side to side and forwards and backwads trims r set to zero and i'm not sure how to bind the controller if possible i will make a video when it's daylight

[cdog0809]

here is a video of how the heli fly's