Separate names with a comma.
sorry it's been a while since i was on. yeah that's not to far. we should GTG some time and hit the trails.
Should be fixed now.
A little some thing iv'e been working on.
i wanted a drift truck that no one else had so i made my own.
Far from done but...
just a couple pic's. i got the rear axle back a little while ago.
i'm having some one make some parts for me but i'm not sure...
OR there is a club further up from you called tri-state scale outlaws. it's a little to far for me right now or i would go sometimes. look'em up...
Hey Mr.calhoun whats up.
it's not really a club just me and my brother. send me a number to text you at in a PM and we can set something up.
OK after a lot more research i found out this chassis is used for a few different cars and i found what i was looking for. i got a front one way...
Well i guess they don't make them.
Thanks to me for once again answering my own question.
Hey guys. i picked up a red cat lightning epx drift for a killer price. i have been doing some research on rc drifting and from all i have read i...
While everyone is distracted i'm going for that 20 bucks.
Pop the axle open and look to if there is any thing causing binding. check to make sure the drive shafts are in phase. i could be that you have...
I think it could be either two things. one is the drive shaft is at to steep of an angle because of the lift in witch case the MIP's you ordered...
Thanks for the tip.
yep found out there both 5mm so it will work. thanks me for answering my own question again.
Ok i'll try it to find out. thanks.
hi guys. i'm starting a project and i need some advise. i'm needing to know if the MIP's drive shafts for the yeti will work on the sxc10 tranny?...
Turned out to be a 4mm grub that holds the shaft to the tranny.
While you guys are talking about your trucks. i'm sneaking in for that 20 bucks. ha ha it's mine now.
OK thanks i'll try that
hey guys got a noob question. i lost the grub screw that holds the shaft to the trans and need to know what size it is so i can grab up a few...