1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Enamels on Polycarbonate

Discussion in 'Mods, Paint & Fabrication' started by soup, Mar 24, 2017.

  1. soup

    soup Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Feb 9, 2017
    Messages:
    340
    Likes Received:
    419
    I painted the interior panel on my yetiXL, sprayed silver from the back then cut away the overspray film and sprayed the drivers with red . On removing the rest of the overspray film found a bit of the red had crept under the film and made a splodge on the silver area . Sprayed a bit of the silver into the cap and brush painted a wee bit silver over the red To give, if not concours, at least a finish acceptable to me .
    Rather than this spray into a lid until there is a pool of Tamiya PS which seems really wasteful, could I have used a wee touch of Humbrol enamel . Always assuming the colours would match of course
     
  2. 00whynot

    00whynot Moderator
    Staff Member MODERATOR

    Joined:
    Jun 19, 2011
    Messages:
    3,861
    Media:
    18
    Likes Received:
    1,130
    wish i had an answer for you. but i think its best myself to stick with one type of paint.
     

Share This Page