Alright so I have decided to redo HEAVY DUTY OVERKILL's rebuild thread. As the old one well I could have done better sooooo here is the new thread!!!!! Here is what went on in the last thread if you did not see: First sat it down, looked it over, found the problems to be addressed, and planed Striped the truck down then made a new frame, This one sit at Exactly at 2 feet!!?!?! It is only bolted in this picture. (Original Extended frame by Rubeboyz RC bottom) And welded/sanded/cleaned up, Original Extended frame by Rubeboyz RC top. It is a very nice frame but had to be extended again so for the strength made an all new one. Now I have a 2 foot long frame now what? Well frames usually have axles mounted under them sooooo three full days of work later..... have the front axle mounted, Center "through" (outputs on both sides) made/mounted & Rear axle flipped (as the rear out put on the Center axle spins in reverse ) Also new mounting brackets made then mounted it. Here is a picture of the center and rear axle. Front is a simple a 4 link set up. Oh by the way all three axles steer Shocks = x6 Gmade 103mm piggy backs Front body mount and Duel battery mount. The batteries are up high BUT the COG (center of gravity) is still great can get 6 inches of articulation before it wants to tip!! Before I go and post update 6 I better put an important link in here: https://www.youtube.com/watch?v=GEpCLFlms78 Hope you like the new thread!!!!!!!!!!!!!!!