Album http://imgur.com/a/njV2d Here’s my project SCX10 Hummer HX. Just a basic SCX10 with a Maisto Hummer HX Body attached. -pause- Oh, no it’s not, my mistake. This truck started life as a Dingo Kit I got December 2015. I got the kit because it was cheaper, not because I wanted a project. Little did I know that getting the kit version would teach me so very much on how to build and fix RCs. After seeing @TracaR 's HX build in the TTC videos, I was set in stone, I needed an HX. NEEDED. Specs Motor: Trackstar 13.5T 3040KV Gearing: 23:54 with Traxxas 32P Pinion / Kimbrough 32P Spur ESC: Hobbywing 1060BL-S in a homemade splashproof box Servo: Bluebird something Metal Gear Analog Receiver: GR3E plastidipped Chassis: HPI Jumpshot MT TVP Transmission: Full metal gears, some RRP I think Front Diff: HPI Spiders with a BIC Spring for a Limited slip Wheels: Some Hobbyking Doroifto rims that I painted black. I wanted some stock car steely rims but this is as close as I got. Now, I’ve found HPI made stock car rims so I think I’ll swap those over. Shocks: Some eBay Chinese shocks with no oil and SC10 Prolite coils Body: Maisto Hummer HX. I wanted a darker gunmetal color with red highlights, but I got lazy and too perfectionist and I wanted to move the project along. Right now it’s really ratty and needs some more touchups. Body is a hingeback with two hard drive magnets to hold the front down. Batteries: I wanted to use the two 3S 5000mAH Zippy in parallel, but I burnt one 1060BL and don’t want to risk blowing another up. Now I use a single 2S 2200. I think this covers everything. Got any questions? Comments? Leave them below! Now, some "beauty" shots. And finally, obligatory flex shot, albiet pretty weaksauce.