1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Suggestions on new axels for the traxxas stampede 4x4 vxl

Discussion in 'Electric' started by Aasensam, May 8, 2013.

  1. Aasensam

    Aasensam New Member

    Joined:
    Apr 29, 2013
    Messages:
    13
    Likes Received:
    0
    I was just fishing for some ideas on new axles or half shafts for my stampede.

    And as always thank you for your suggestions.
     
  2. hvydingo

    hvydingo Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Aug 10, 2012
    Messages:
    1,025
    Likes Received:
    13
    I hear MIP cvd's are good for the pede,but that moves the weakest link to some other place.That is the reason I still use stock driveshafts.I would rather break at $5 piece instead of a $50 rear end or something else.I use 3s in my 4x4 pede just with some throttle control and the driveshafts hold up pretty good until I want to do some flips.
     
  3. Aasensam

    Aasensam New Member

    Joined:
    Apr 29, 2013
    Messages:
    13
    Likes Received:
    0
    thanks and i think that i am going to go with stock driveshafts also because then it would break somewhere else like you said
     
  4. ScaleBasher

    ScaleBasher Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Apr 28, 2012
    Messages:
    939
    Likes Received:
    1
    Im running my Pede 4x4 with MIP driveshafts and LOVE them! They lower your center of gravity! Also I put a 1/8th scale motor esc in my Stampede 4x4 so it needed the durability! Have yet to break anything else since installing them!
     

Share This Page