1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

MONSTER TRUCKS Summit High and Low Gear no longer working

Discussion in 'Bashing Chat' started by BlackPhoenix, Mar 5, 2013.

  1. BlackPhoenix

    BlackPhoenix Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Aug 23, 2011
    Messages:
    1,015
    Likes Received:
    11
    Hey guys so after jumping my Summit over my back fence yesterday after the run I noticed that when I flicked the switch to change down to low gear nothing happened. I took the body off and tried again but the little servo wasn't moving at all. I checked the diff locking switch and they all work fine it's just the high and low gear servo. I am pretty sure that it is the servo that is busted so I am looking at buying a new one but does anyone know which port in the receiver it goes to? So I don't have to pull each one of them out. Thanks
     
  2. 70hemicuda

    70hemicuda Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Jan 22, 2013
    Messages:
    129
    Likes Received:
    2
  3. BlackPhoenix

    BlackPhoenix Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Aug 23, 2011
    Messages:
    1,015
    Likes Received:
    11
    Thanks hemi. Ill check the Summit in the morning. Its 11:30 now. :(
     
  4. 70hemicuda

    70hemicuda Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Jan 22, 2013
    Messages:
    129
    Likes Received:
    2
    lol its 7:40 in the morning here lol. i just got off work and im passing out as well. hahahaha
     
  5. seredith

    seredith Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Jan 28, 2013
    Messages:
    182
    Likes Received:
    2
    Let us know if that fixes it. I'm watching these threads to keep an eye out for issues that may come up on my summit. Good luck sir.
     
  6. Azrayel74

    Azrayel74 Dr. Madness
    MODERATOR

    Joined:
    May 8, 2011
    Messages:
    1,339
    Likes Received:
    15
    I just checked my 1st Gen E-Maxx which is setup with a similar system to the Summit with a 2 speed tranny and my shift servo is plugged into Channel 3 and works off of the red 2 position side switch on the 2.4Ghz controller. Hope this helps and good luck getting yours back up sooon..
     
  7. summitnut

    summitnut Super Moderator
    SUPER MODERATOR

    Joined:
    Jan 28, 2011
    Messages:
    2,315
    Media:
    1
    Likes Received:
    715
    Yes channel 1 x2 steering
    Ch 2 esc
    Ch3 hi/low
    Ch4 frt diff loc
    Ch5 rear diff loc
    When you install the new one make sure it is not going to far one way or the other it will over work it and burn it up
    Check all the micros they don't stand up for long if out of adjustment
     
    #7 summitnut, Mar 5, 2013
    Last edited: Mar 5, 2013

Share This Page