1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

TRX 3.3 engine

Discussion in 'Race - Engines, Tuning & Exhaust' started by Scarefox, Jul 20, 2013.

  1. Scarefox

    Scarefox New Member

    Joined:
    Jul 12, 2013
    Messages:
    28
    Likes Received:
    0
    hey guys anyone got expierence with removing this engine from a Nitro 4-tec? i will have to take it of my vehicle to replace the carb so any advice is helpfull
     
  2. Koreyh2010

    Koreyh2010 Studio Forums Elite
    ELiTE MEMBER

    Joined:
    May 21, 2013
    Messages:
    303
    Likes Received:
    5
    Usually just like 4 bolts on the bottom and i would just start unhooking stuff :D if all your replacing is the carb i would just take it off
     
  3. Scarefox

    Scarefox New Member

    Joined:
    Jul 12, 2013
    Messages:
    28
    Likes Received:
    0
    thanks but apairantly there is a hole where the rear bodymounts are wich you can put a hex wrench can fit through
     

Share This Page