1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Velcro or 2 sided tape

Discussion in 'RC Chat, Tutorials, Ideas, Requests, Etc' started by Wackycanada, Jun 25, 2014.

  1. Wackycanada

    Wackycanada New Member

    Joined:
    Jun 9, 2014
    Messages:
    10
    Likes Received:
    0
    On my G6 RTR the ESC was mounted near the motor and was hitting the drive shaft I want to move it to the top of the receiver cover.. it was mounted with 2 sided tape but it seemed to fail very fast when it was close to the motor hence the move for it.. now i'm looking at either 2 sided tape to re-mount it or velcro.. I would like some advice on this for what you all think would be best.. ( Currently I have some cheap velcro holding the ESC but it doesn't seem to me strong enough. )
     
  2. cbaker65

    cbaker65 Studio Forums Elite
    ELiTE MEMBER

    Joined:
    Oct 12, 2013
    Messages:
    807
    Likes Received:
    173
    Ive done both,but Also did a zip tie if there is a clear spot on the ESC.The important thing is
    to make sure you dont smother it,an also its good to have something under it to provide
    a little cusion for vibration or hard jolts.
     

Share This Page